ELECTRICAL REQUIREMENTS - GAS DRYER
Customer Service Troubleshooting Tips Operating Instruction Installation Instructions Safety Instructions
Gas Dryers
(120 Volt, 60 Hertz, with
NOTE : The wiring diagram is located inside the control panel, inside the control cabinet.
WARNING
To reduce the risk of fire, electric shock or personal injury, all wiring and grounding MUST confirm with the latest edition of the National Electrical Code ANSI/NFPA 70 or the Canadian Electrical Code, CSA C22.1, and such local regulations as might apply. It is the customer’s responsibility to have the wiring and fuses checked by a qualified electrician to make sure the laundry room has adequate electrical power to operate the dryer.
●The dryer is designed to be operated on a separate branch, polarized,
●The
WARNING
This dryer is equipped with a three- prong (grounding) plug for your protection against shock hazard and should be plugged directly into a properly grounded
NOTE : A qualified electrician should check the polarity of the wall receptacles. If a voltage reading is measured other than that illustrated, the qualified electrician should correct the problem.
●DO NOT OPERATE OTHER APPLIANCES ON THE SAME CIRCUIT WHEN THIS APPLIANCE IS OPERATING. DO NOT OVERLOAD CIRCUITS!
●DO NOT operate both a washer and gas dryer on the same circuit. Use separately fused 15 Amp circuits.
WARNING
To reduce the risk of an electric shock or fire, DO NOT use an extension cord or an adapter to connect the dryer to the electrical power source.
DO NOT OVERLOAD
CIRCUITS
DO NOT USE AN
ADAPTER
DO NOT USE AN
EXTENSION CORD
1 6
