Installation and Setup
TV Connections
Make one of the following connections, depending on the capabilities of your existing equipment.
Tips:
Depending on your TV and other equipment you wish to connect, there are various ways you could connect the DVD/CD Receiver. Use one of the connections described below.
Please refer to the manuals of your TV, VCR, Stereo System or other devices as necessary to make the best connections.
Caution
–Make sure the DVD/CD Receiver is connected directly to the TV. Select the correct AV input on your TV.
–Do not connect your DVD/CD Receiver to TV via your VCR. The DVD image could be distorted by the copy protection system.
S-Video connection
Connect the
Video connection
Connect the MONITOR OUT jack from the DVD/CD Receiver to the VIDEO IN jack on the TV using the video cable supplied (V).
Progressive Scan (ColorStream® pro) connection
If your television is a
If your TV does not accept the Progressive Scan format, the picture will appear scrambled if you try Progressive Scan on the DVD/CD Receiver.
Notes:
•Set the Progressive to “On” on the setup menu for progressive signal, see page 19.
•Set the progressive to “Off” by removing any disc from the unit and close the disc tray. see that “no disc” is displayed on the display window. Then press STOP and hold it for five seconds before releasing it.
•Progressive scan does not work with the analog video connections (yellow VIDEO OUT jack).
Rear of TV
VIDEO |
| COMPONENT VIDEO / | ||
INPUT | INPUT | PROGRESSIVE SCAN INPUT | ||
| L | Y | Pb | Pr |
|
|
|
| |
Introduction
Component Video (Color Stream®) connection
Connect the COMPONENT VIDEO OUT jacks from the
DVD/CD Receiver to the corresponding in jacks on theS V C TV using an Y Pb Pr cable (C).
11
