To Install as a Slave Drive
To install the drive as a Slave, change the jumper setting on the rear panel to SL.
Master drive |
(Booting hard disk) |
Slave drive (Super Multi DVD Drive) (Jumper set to Slave)
Master drive | Master drive |
(Booting hard disk) | (Other IDE drive) |
- OR - | Slave drive |
| (Super Multi |
| DVD Drive) |
Primary | (Jumper set |
connector | to Slave) |
Secondary connector
Connecting the Power Connector
Connect the power cable from the computer’s power supply to the socket on the drive unit, fitting the connector firmly into the power in connector. If there is no spare power cable available in the computer, you will have to purchase a splitter cable of a suitable type.
|
|
| CD INPUT |
| |
|
|
| 5V | GND | 12V |
|
| DC | INPUT |
|
|
SELECT | IDE INTERFACE | CONNECTOR |
|
|
|
AUDIO OUT |
|
|
|
|
|
Beveled edge up 
NOTE : Improper connection may damage the drive and void the warranty. Generally, the power connector can only fit one way.
Connecting the Interface Connector
Connect the
AUDIO OUT R GND L
SELECT C.SEL SLMAVAESTER
39 40
IDE INTERFACE | CONNECTOR |
|
DC
15V
INPUT GND 12V
Pin1 | NOTE : Generally, the IDE connector is keyed |
| and will only fit one way. |
6
