9. INSTALLATION INSTRUCTION
Step 1: PREPARE CUPBOARD OPENING
1.This dishwasher is designed to fit a standard dishwasher opening as shown below.
2.Select a location as close to sink as possible for easy connections to water and drain lines.
3.The dishwasher should not be installed more than 10 ft. (3m) from the sink for proper drainage.
4.If dishwasher is to be installed in a corner, a minimum of 2 in. (50mm) is required between the dishwasher and an adjacent a wall.
If dishwasher will sit directly on subflooring, subfloor should be sealed with a waterproof paint or sealer to prevent damage from steam.
Drill a
approx. 4″(100mm, W) X 4″(100mm, H)
These openings must be within 4″ (100mm) from the floor and
■Ensure the floor under the dishwasher is at the same level as the rest of the room to allow for any service requirements.
- 27 -