Step 7: WATER SUPPLY CONNECTION
1.When connecting, sealing tape or sealing compound should be used to avoid water leaks.
2.Before connecting, turn off the water supply.
3.After fitting the Elbow into the Inlet Valve, slide the Flexible Stainless Tube or Copper Tube into the Elbow.
4.Tighten the nut and make sure that the line is not kinked or sharply bent.
Inlet Valve
Elbow
Water Supply Tube
Step 8: ELECTRICAL POWER CONNECTION
1.Before beginning, turn off electrical power to the unit at the circuit breaker.
2.Remove the Junction Cover and then Install the Strain Relief.
3.Twist Wire Connectors tightly on the wires. Wrap each connection with Electrical tape.
Junction Cover
4.Check again and make sure that all wires are connected correctly, black to black, white to white, green to green (ground to ground).
5. Replace the Junction Cover.
Wire Connector
Junction Case
Strain Relief
black to black
green to green (ground to ground)
white to white
- 32 -