Optibin Crispers, Removing Crisper | LG Electronics LFC25760

USING YOUR REFRIGERATOR

OPTIBIN CRISPERS

2

1

uCrispers with rails To remove the crisper

1. Pull the drawer out to full extension.

2. Lift the front of the crisper up and pull it straight out.

The Optibin Crispers provide fresher-tasting fruit and vegetables by letting you easily control humidity inside the crisper. The Optibin Crispers include: 1) a humidity control knob at the front of the crisper cover and 2) a large lattice on the inner surface of the cover to hold or release moisture.

CRISPER HUMIDITY CONTROL

You can control the amount of humidity in the moisture- sealed crispers. Store vegetables or fruits requiring more or less humidity in separate crispers. Adjust the control to

any setting between and .

• lets moist air out of the crisper for best storage of fruits.

• keeps moist air in the crisper for best storage of fresh, leafy vegetables.

wCAUTION: The glass shelf over the crisper is not firmly secured. Be careful when tilting.

REMOVING CRISPER

uCrispers without rails

1.To remove, pull the drawer out to full extension.

2.Lift the front of the crisper up, then pull it straight out.

3.To install, slightly tilt up the front and insert the drawer into the frame and push it back into place.

To replace the crisper

1.Push rails to the back of the compartment.

2.Insert the back corner of the crisper into the frame.

3.Slightly tilt up the front and push the drawer back until it snaps into place.

20

Image 20

LG Electronics LFC25760 manual Optibin Crispers, Crisper Humidity Control, Removing Crisper

Contents

Congelador Inferior Refrigerador Table of Contents LG ELECTRONICS, INC LG Refrigerator Limited Warranty USA Authorized Service Center. Phones are answeredPlease call 1-800-243-0000 and choose Appropriate option to locate your nearest LG Limited Warranty Canada LG Refrigerator Do not modify or extend the power Cord length Safety MessagesRead all instructions before using this appliance CFC Disposal Grounding RequirementsTo Connect Electricity Recommended Grounding Method Parts and Features Refrigerator Installation InstallationUnpacking Your Refrigerator Next Removing Freezer Drawer Handle HOW to Remove Door HandlesRemoving Refrigerator Handle HOW to Replace Door Handles Replacing Refrigerator Door HandleReplacing Freezer Drawer Handle Screws Mounted On door HOW to Remove Refrigerator Door Removing Refrigerator DoorLeft Door Right Door Replacing Refrigerator Door Right Door HOW to Remove and Install the Pullout Drawer Removing Pullout Drawer Installing Pullout Drawer Door Alignment Leveling and Door AlignmentLeveling Using Your Refrigerator Setting the ControlsEnsuring Proper AIR Circulation MULTI-FLOW Adjusting Control Settings Food Storage Guide Storing Frozen Food PackagingPackaging recommendations Do not use Adjusting Shelves Refrigerator ShelvesBottle Holder Sliding Out Shelves Removing Crisper Optibin CrispersCrisper Humidity Control Crisper Cover with Lattice on Inner Surface To remove the crisper door flapTo remove the glass To remove the lattice on inner surface GLIDE‘N’SERVE Modular Door BINCold Temp Control Colder Controls To remove Glide‘N’Serve EGG BOX Dairy BINICE BIN Pull OUT Drawer DurabaseDurabase Divider Care and Cleaning Power Interruptions When YOU GO on VacationWhen YOU Move To change freezer light When YOU should SET the Icemaker Power Switch to O OFF About the Automatic IcemakerOperation Instructions Normal Sounds YOU MAY Hear Connecting the Water Line Fasten the Shutoff Valve Connect the Tubing to the ValveTighten the Pipe Clamp Flush OUT the Tubing Connect the Tubing to the Refrigerator Turn the Water on AT the Shutoff ValvePlug in the Refrigerator Start the Icemaker Troubleshooting Guide Refer to the Setting the Controls sectionUnderstanding Sounds YOU MAY Hear Check if… Then… See the Adjusting Control Settings section Completely belowSee Leveling and Door Alignment on Door Alignment section on May Hear section on Production. See the Setting the ControlsRefer to the Understanding Sounds You See Doors will not close completely on Memo