CONNECTING THE WATER LINE

9.CONNECT THE TUBING TO THE REFRIGERATOR

Removing and Replacing Valve Cover

NOTE:

Before making the connection to the refrigerator, be sure the refrigerator power cord is not plugged into the wall outlet.

1.Remove the plastic flexible cap from the water valve.

2.Place the compression nut and ferrule (sleeve) onto the end of the tubing as shown.

3.lnsert the end of the copper tubing into the connection as far as possible. While holding the tubing, tighten the fitting.

wCAUTION: Check to see if water dripping occurs at water line connections.

10.TURN THE WATER ON AT THE SHUTOFF VALVE

Tighten any connections that leak.

Reattach the compressor compartment access cover.

11. PLUG IN THE REFRIGERATOR

Tubing Clamp

1/4 " Compression Nut

Ferrule (sleeve)

1/4 " Tubing

Refrigerator

Connection

Arrange the coil of tubing so that it does not vibrate against the back of the refrigerator or against the wall. Push the refrigerator back to the wall.

12. START THE ICEMAKER

Set the icemaker power switch to the ON position. The icemaker will not begin to operate until it reaches its operating temperature of 15°F (–9°C) or below. It will then begin operation automatically if the icemaker power switch is in the I (on) position.

30

Page 30
Image 30
LG Electronics LFC25760 Connect the Tubing to the Refrigerator, Turn the Water on AT the Shutoff Valve, Start the Icemaker