STEP 3: Prepare The Venting Blower
WALL-VENTED INSTALLATION:
1.Remove one blower unit mounting screw and one or
several blower plate mounting screw(s). Remove the blower plate from cabinet. See Figure 13.
2.Carefully lift the blower unit out of the microwave oven.
3.Use side cutters or tin snips to cut and remove knockouts
B from Back plate. Discard knockouts. Be careful not to distort the plate. See Figure 14.
4.Reassemble the blower wire. See Figure 15.
5.Rotate the blower unit so that the exhaust ports face the rear of the cabinet. See Figure 16.
6.Place blower unit back into cabinet. Check that the exhaust
ports face towards the rear of the cabinet. Be sure the wires are not pinched. See Figure 17.
7.Reattach the blower plate to cabinet so the exhaust ports and blower plate opening are aligned. Attach with one
blower unit mounting screw and then one or several blower plate mounting screw(s). See Figure 18.
Blower Plate
Mounting Screw
Blower Plate
Back Plate
Blower Unit
Blower Unit
Mounting Screw
Parts B
Figure 13
Knockouts Parts B
Parts B
Figure 14
Blower
Unit
Exhaust Ports
Figure 15 | Figure 16 |
Blower Plate
Mounting Screw
Blower Plate
Blower Unit
Back Plate
Exhaust |
| Blower Unit | |
Ports |
| ||
Blower Unit | Mounting Screw | ||
| |||
| Exhaust Ports |
| |
Figure 17 |
| Figure 18 |
– 11 –
