Heat & Glo LifeStyle ST-36TRLP-IPI C. Blower Kit optional, Blower Installation, D. Clear Space

C. Blower Kit (optional)

If desired, a blower kit may be added. Contact your deal- er to order the correct blower kit.

Blower Installation

1.Place blower in appliance as shown in Figure 2.2.

2.Wire the blower and temperature sensor as shown in Figure 12.2.

3.Attach temperature sensor switch by placing the switch onto the threaded stud indicated in Figure 2.2 and then threading the wing nut onto the stud.

E. Decorative Doors and Fronts

WARNING! Risk of Fire! Install ONLY doors or fronts approved by Hearth & Home Technologies. Unapproved doors or fronts may cause fireplace to overheat.

This fireplace has been supplied with an integral barrier to prevent direct contact with the fixed glass panel. DO NOT operate the fireplace with the barrier removed.

Contact your dealer or Hearth & Home Technologies if the barrier is not present or help is needed to properly install one.

	THREADED STUD
Figure 2.2	Blower Location

For more information refer to the instructions supplied with your decorative door or front.

F. Fixed Glass Assembly

See Section 14.G.

G.Remote Controls, Wall Controls and Wall Switches

Follow the instructions supplied with the control installed to operate your fireplace:

For safety:

•Install a switch lock or a wall/remote control with child protection lockout feature.

D. Clear Space

WARNING! DO NOT place combustible objects in front of the fireplace or block louvers. High temperatures may start a fire. See Figure 2.3.

Avoid placing candles and other heat-sensitive objects on mantel or hearth. Heat may damage these objects.

•Keep remote controls out of reach of children. See your dealer if you have questions.

H. Before Lighting Fireplace

Before operating this fireplace for the first time, have a qualified service technician:

					•	Verify all shipping materials have been removed from
						inside and/or underneath the firebox.
					• Review proper placement of logs, ember material and/or
						other decorative materials.
					•	Check the wiring.
					•	Check the air shutter adjustment.
					•	Ensure that there are no gas leaks.
					• Ensure that the glass is sealed and in the proper position
						and that the integral barrier is in place.
					WARNING! Risk of Fire or Asphyxiation! DO NOT op-
					erate fireplace with fixed glass assembly removed.
	3	FT.	CLEAR
		IN
			FRONT OFSPACE
			FIREPLACE
Figure 2.3	Clear Space
10			Heat & Glo	•	ST-36TR-IPI, PIER-36TR-IPI • 2176-900 Rev. F • 8/11