C. Securing and Leveling the Appliance
WARNING! Risk of Fire! Prevent contact with:
•Sagging or loose insulation
•Insulation backing or plastic
•Framing and other combustible materials
Block openings into the chase to prevent entry of blown- in insulation. Make sure insulation and other materials are secured.
DO NOT notch the framing around the appliance standoffs.
Failure to maintain air space clearance may cause overheating and fire.
NOTICE: Failure to ensure that the fireplace opening is square may result in the decorative front not fitting properly.
The diagram shows how to properly position, level, and secure the appliance (see Figure 9.8). Nailing tabs are pro- vided to secure the appliance to the framing members.
1.Venting - refer to Vent Clearances and Framing (Section 8) for hole location.
2.Place the appliance into position, making sure to maintain proper clearance to combustibles.
3.Level the appliance from side to side and front to back. It is acceptable to use wood shims under the appliance.
4.Fasten the appliance to the floor using the pilot holes located at the bottom of the appliance.
5.Bend out nailing tabs on each side making sure to keep the nailing tabs flush with the framing.
6.Using a framing square, make sure that the sides of the appliance are square to the bottom as shown in Figure 9.9.
7.Secure the appliance to the framing by using nails or screws through the nailing tabs. It is acceptable to use plumber strap to secure the unit to the framing if necessary. Be sure to maintain all clearances to combustible material.
Note: Once appliance is setup for top or rear venting, it CANNOT be changed at a later time.
NAILING TABS |
Figure 9.8 Securing An Appliance |
| 90º | |
SIDE | TO | SIDE |
| ||
|
| |
|
| BACK |
|
| TO |
|
| FRONT |
Figure 9.9 Proper Positioning and Leveling of an Appliance | ||
42 | Heat & Glo • |
