Configuration Options via GUI (Cont.)
Modify Tuner/Channel Assignments
1.Click on the down arrow at the right of each Channel field you wish to reassign, and select from the
2.When you have completed the assignments, click on the Set button at the bottom of the Channel column.
3.The system will display a
•Click OK to confirm and apply the new assignments.
•Click Cancel to return to the Input Channels screen without saving your changes.
If you successfully change the tuner/channel assignments, the system will display 
at the bottom of the Input Channels screen.
OAT100R System Setup Options
The System Setup screen enables you to view and/or modify the system configuration. To access the System Setup screen, click on System Setup in the options panel at the left of the screen (see example on following page).
On the left side of the System Setup screen, the System Information section provides important information about the current configuration of the OAT100R, including the unit serial number, software version, hardware ID (firmware version), Control Port MAC and IP addresses, and output configuration. On the right side of the screen, several menu options are available, as described in the following subsections.
Configure the Program PIDs
If any Pro:Idiom channels are configured in the site’s entertainment system, you must configure program PIDs for the OAT100R output in the Program PID section of the System Setup screen. See “Packet Identifiers (PIDs) Overview” on page 10 for further information, and/or check with your service representative, if necessary. Type the starting program PID number in hexadecimal format in the Start PID Number field, and then click on the Set button at the right of the field. The system will
If you successfully set the starting program PID, the system will display 
at the bottom of the System Information display. The System Information display will also show the updated program PID range.
Identify the Site Location
In the Location Description section of the System Setup screen, you can identify the site in which the OAT100R is installed. Type the location description directly into the text field provided, and then click on the Set button at the right of the field. If you successfully set the location
description, the system will display 
at the bottom of the System Information display.
If specified in the System Setup screen (as described above) or in the command line interface Setup Menu, the site location is identified in blue text at the right of the System Status and Tuner Information screen titles.
30 |