I nstallation
Level adjustment
| Lock nut |
| Adjustable feet |
Higher | Lower |
Adjustable feet | Adjustable feet |
1.Adjusting the washing machine level properly prevents excessive noise and vibration.
Install the appliance on a solid and level floor surface, preferably in a corner of the room.
NOTE: Extend the feet no more than necessary to level the washer. The more the feet are extended, the more the washer will vibrate.
2.If the floor is uneven, adjust the adjustable feet as required. (Do not insert pieces of wood etc. under the feet)
Make sure that all four feet are stable and resting on the floor and then check that the appliance is perfectly level.
(Use a spirit level)
❊After the washer is level, tighten the lock nuts up towards of the base of the washer. All lock nuts must be tightened.
NOTE: If there are vibration and noise during the spin cycle,
Run the washer with a test load to make certain your washer is properly leveled. Put approximately 6 pounds of laundry in the machine. Then, press POWER, RINSE+SPIN, and START/PAUSE, in that order. When the machine spins at high speed, verify that it is stable. If not, adjust
❊Diagonal Check
When pushing down the edges of the washing machine top plate diagonally, the machine should not move up and down at all. (Please, check both of two directions)
If machine rocks when pushing the machine top plate diagonally, adjust the feet again.
9
