26

Under fault conditions, the Fault indicators will be illuminated indefinitely

while battery charger is operational, or for a maximum of 5 minutes while

battery charger is not operational.

If a problem persists, consult your local dealer, Liebert representative or

contact the Liebert Worldwide Support Group. Please have the UPS

model number and serial number available at the time of your inquiry.

Troubleshooting Guide
Problem Cause Solution
UPS fails to start
when the ON
button is pressed.
UPS is short circuited or
overloaded.
Ensure UPS is OFF.
Disconnect all loads and
ensure nothing is lodged in
output receptacles. Ensure
loads are not defective or
shorted internally.
Battery indicator
LED is illuminated.
UPS not plugged in. UPS is operating from
battery mode, make certain
UPS is securely plugged
into the wall receptacle.
UPS input protection fuse
has blown/opened.
UPS is operating from
battery mode. Save data
and close applications.
Replace UPS input fuse,
then restart UPS.
Utility voltage out of UPS
input range.
UPS is operating from
battery mode. Save data
and close applications.
Ensure utility supply voltage
is within acceptable limits
for UPS.
UPS has reduced
battery time.
Batteries are not fully
charged.
Keep UPS plugged in
continuously at least 24
hours to recharge batteries.
UPS is overloaded. Check load level display
and reduce the load on the
UPS.
Batteries may not be able to
hold a full charge due to
age.
Replace batteries. Contact
your local dealer, Liebert
representative or the Liebert
Worldwide Support Group
for replacement battery kit.