Getting Started With the Web Interface
5.4Power Window (EM PDU & vEM-14 Controllers)
The Power tab provides access to MP Advanced Power Strips connected to the OpenComms EM, including:
•Turning receptacles on or
•Setting thresholds that will trigger alerts (see 5.4.2 - Configure Thresholds)
•Viewing graphs of power strip data (see 5.4.3 - View Power Strip Graphs)
•Creating display names for any power strip (see 5.4.4 - Create or Change Port Names)
5.4.1Control Receptacles
The Power Data window allows you to turn power strip receptacles on or off through the Web inter-
To access the Power Data window, log in (see 5.1 - Open the Web Interface and Log In) and:
•Click on the Power tab at the top of the Web interface, as shown below.
Figure 7 Power tab
Select a power strip
Refresh button
Power tab
Links to set thresholds
All On / All Off
Individual receptacle controls
Linked receptacles
4 & 7 (Port 1)
•Select a port from the left side of the window by clicking on the name of the port. The right side of the window shows the selected power strip, its status and current readings.
Control All Receptacles With One Button
•Two buttons below the readings allow you to control all receptacles at once:
•Click the All On button to turn on all receptacles in the power strip.
•Click the All Off button to turn all receptacles off.
Control Individual Receptacles
•The receptacle controls at the bottom of the window allow you to turn individual receptacles on or off, reboot them and link the controls of two receptacles.
•Click the On button to turn a receptacle on.
•Click the Off button to turn it off.
•Click Reboot to turn a receptacle off for ten seconds and then back
22