Installation
Place rear rail [R] over the studs in the front rail [F]. Tighten nuts finger tight. The mounting tab [T] will be facing out, so the holes align with the rack sides. Adjust length of rail assembly to fit inside rack. Tighten either the wing nuts or hex nuts.
Insert cage nut (one on each side) in rack. Set hooks at rear of rail over holes in rack. Use screw [2] (one on each side) to attach rails to rear of rack through cage nut. Use screw [2] (two on each side) to attach rails to front of rack.
| R | |
| F | |
T |
| |
OUTSIDE | FRONT | |
2 | ||
|
Use screws [1] (two on each side) to attach brackets to side of unit. Slide unit into rails and secure by using screws [2] (one on each side) to attach the unit.
1
2
1
DISCONTINUED
PRODUCT