Liebherr 7085638-01 Changing over the door hinges, Putting into operation, Detaching the door

Putting into operation

u Align the appliance so that it stands firmly and on a level by applying the accompanying spanner to the adjustable- height feet (A) and using a spirit level.

u Then support the door: Extend the adjustable foot at the turn hinge (B) until it rests on the floor and then make a further 90° turn.

When a Side-by-Side appliance (S…) is fitted together with a second appliance (as a SBS combination):

u Proceed according to the Side-by-Side combined fridge- freezer installation instructions. (Accessories bag of the SBS freezer/appliance with freezer compartment)

Note

u Clean the appliance (see 6.2) .

If the appliance is installed in a very damp environment, condensate may form on the outside of the appliance.

u Always see to good ventilation at the installation site.

4.3 Changing over the door hinges

You can change over the door hinges if necessary.

NOTICE

Risk of damage to side-by-side appliances due to condensa- tion!

When a side-by-side appliance (S…) is fitted together with a second appliance (as a SBS combination), the door hinges must remain as delivered.

u Do not change over the door hinges.

Ensure that the following tools are to hand: q Torx® 25

q Torx® 15 q Screwdriver

q Battery-powered screwdriver, if necessary q Second person for fitting work, if needed

4.3.1 Detaching the door

Note

u Remove any food from the door racks before removing the door, so that no food falls out.

Fig. 4

u Close the door.

u Pull off the cover Fig. 4 (10) forwards and upwards. u Lift off the cover Fig. 4 (11).

CAUTION

Risk of injury if the door tips! u Take good hold of the door. u Set down the door carefully.

u Unscrew the upper turn hinge Fig. 4 (12)(2x Torx® 25) Fig. 4 (13) and lift it off.

u Lift off the door and set it aside.

4.3.2 Changing the bearing parts

Fig. 5

u Lift out the bearing pin Fig. 5 (22) together with washer Fig. 5 (23) and adjustable-height foot Fig. 5 (24).

u Lift off the stopper Fig. 5 (21).

u Unscrew Fig. 5 (26) the turn hinge Fig. 5 (25).

u Unscrew Fig. 5 (29) the bearing element Fig. 5 (28) , transfer it to the opposite location hole of the turn hinge and screw it firmly into place.

u Carefully lift off the cover on the handle side Fig. 5 (27) and transfer it to the opposite side.

u Screw the turn hinge Fig. 5 (25) firmly into place on the new hinge side, possibly using a cordless screwdriver (with 4 Nm).

u Re-insert the stopper Fig. 5 (21) into the other hole.

u Re-insert the bearing pin Fig. 5 (22) together with the washer and adjustable-height foot. In so doing, pay attention that the locating lug points backwards

4.3.3 Transferring the handle
u Transfer the spring clamp
Fig. 6 (31): Depress the
latch nose and pull the
spring clamp off over it.
u Slide the spring clamp
into place on the new
hinge side until it clicks
into place.	Fig. 6

6 * Depending on model and options