Liebherr BFI1051 Connection to the Water Supply, Figures 23, Icemaker, A delight in freshness

ICEMAKER

Connection to the Water Supply -

Figures 23, 24

1.Install the shut-off valve, water filter and automatic shut-off device as required.

Note

The solenoid valve is located at the rear of your unit.

2.The 1/4" copper tubing between the shut-off valve and solenoid valve has a 3/4" male connector (Figure 24). Make sure there is approximately 27" (70 cm) of excess tubing behind the unit for easy connection.

Note

A 3/4" to a 1/4" adapter and cable clip are supplied with the icemaker.

Remove the cover cap (4) from the solenoid valve (1). Install the connection bracket (2) with sealing ring (6) on the solenoid valve (1). Attach the copper tube to the connection bracket (2). Secure the copper tube (3) to the appliance using the cable clip (5).

3.Open the shut-off valve for the water supply and check the entire water system for leaks. Before the appliance is used for the first time a licensed plumber should bleed air from the system.

4.Insert the electrical plug for the combined refrigerator/freezer into the electrical outlet (Figure 23).

5.Move the combined refrigerator-freezer into final position in the room.

Figure 23

A delight in freshness

24 BFI/BF1051 / BGEN/es 2956