REVERSING DOOR HINGES - CI 16
IMPORTANT
If the hinges and door handles are reversed, you must obtain the Reverse Set. The Reverse Set is not included with the unit.
!CAUTION
Changing the door stop must be made by two people to prevent personal injury and damage to the doors.
1.Remove the upper ventilation grille if already installed.
2.Remove the screw (1) at the door fixture.
!CAUTION
Secure door to prevent personal injury and to prevent the door from falling down.
3.Remove spacers (2).
The door can now be lifted and placed on the floor.
4.Pull out the bearing pin (3) at the door fixture center.
!CAUTION
Secure door to prevent personal injury and to prevent the door from falling down.
5.Lift the door and place it on the floor.
6.Remove the door fixture (4).
7.Loosen the screws at the door fixture.
8.Remove the screw (5) at the lower door fixture and turn it into the other bore.
The door fixture down can be mounted again on the other side (6).
9.Pull out plastic sleeve and assemble on the opposite side of the bracket (7).
10.Remove both screws (8) at the back of the installation frame.
11.Remove the 18 mounting screws (9) to dismantle the installation frame.
12.Mount the installation frame.
13.Mount the right installation frame (10) on the other side. Discard the two other frames (11).
14.Mount the two enclosed frames (12) on the right side. Do not forget the angle bracket corner (13).
15.Lock the angle bracket (13) with the installation frame.
16.Remove the door mounting from the refrigerator and attach it on the other side (14).
17.Remove hinge sockets (15).
18.Remove door change frames (16).
19.Pull out
20.Remove screws (19).
21.Remove handle (18).
22.Remove the other door change frames (20) and mount them on the opposite side.
23.Insert handle brackets (21) again into the slots and attach handle.
24.Push
25.Mount door change frames above and down (23).
26.Insert hinge socket (24) into the frames.
27.Attach hinge socket (25) with screws to the door.
28.Follow these instructions to change the other door.
29.Insert spacers (26) for the upper door.
30.Attach center door fixture (27).
31.Place down lower door again on the lower door mounting bracket.
32.Insert the metal pin (28) into the sleeve.
33.Position other door on the door mounting center. Use other spacer (29) and attach door with hinge bolt (30).
34.Mount the upper ventilation grille (Figure 11).
A delight in freshness
18 | C 16/CI 16 |
