Liebherr HCS 20 Mounting the refrigerator door panels - Figures, Installation

INSTALLATION

Mounting the refrigerator door panels - Figures 21 - 28

1.Open the left refrigerator door and suspend the panel on the adjusting bolts Figure 21.

2.Screw on the hex nuts to the adjusting bolts and tighten temporarily Figure 21.

Figure 21

3.Loosen the three cross-head screws of the bracket and move the panel to the left until it makes contact with the center rail Figure 22.

4.Tighten the three cross-head screws Figure 22.

5.Close the door and check the height of the panel.

6.Align the panel in its vertical position if necessary. Loosen the hex nuts and turn the adusting bolts using a screwdriver for slotted screws. Figure 23.

7.Check the vertical position of the panel again and tighten the hex nuts finally.

Figure 23

To make it possible to fasten the refrigerator panel at the bottom the soft-stop cylinder must be dismantled.

8.Stick a small screwdriver under the retaining clamp and lever out. Figure 24.

Figure 22 Figure 24

12