Liebherr HCS 20 Icemaker, IceMaker, Safety Instructions and Warnings, Water Connection

ICEMAKER

IceMaker

The icemaker for a combined refrigerator-freezer is located in the freezer compartment. It must be connected to the water supply to function properly. These instructions only refer to the installation of the icemaker. Please refer to the Use and Care Manual provided with the appliance for operation instructions. The combined refrigerator-freezer must be level for the icemaker to function properly.

Safety Instructions and Warnings

•Do not install the water connection while the combined refrigerator-freezer is connected to an electrical outlet.

•The connection to the water supply may only be made by a trained and licensed plumber.

•The water quality must comply with the drink- ing water regulations for the geographical area where the appliance is located.

Water Connection

•The water pressure must be between 21.8-87.0 psi (1.5-6 bar).

•Use a 1/4" OD copper line to connect the water supply to the solenoid valve. This is not sup- plied with the refrigerator (Figure 9).

•A shut-off valve, such as the saddle valve illus- trated here, must be installed between the hose line and the main water supply so the water sup- ply can be stopped if necessary.

Do not install the shut-off valve behind the refrigeration unit.

•If you have hard water, we recommend you install a water softener. Also, a filter must be installed if the water contains solids such as sand.

•All equipment and devices used to supply the water to the appliance must comply with the cur- rent regulations for your geographical area.

Cover strips - Figure 10

Before connection to the water supply, the cover strips provided must be fitted to the appliance. It is necessary because the appliance will be moved into its recess.

•Remove the cover band from the strips and stick them to the left and right front edge of the appli- ance housing (Figure 10).

Figure 10

Figure 9

8