Liebherr liebherr manual Mounting the refrigerator panel, Fig. B

Mounting the refrigerator panel

The description is for one panel only. The procedure is the same for both panels.

1.Open the refrigerator door and suspend the refrigerator panel on the top adjusting pins (fig. B).

2.Screw securing nuts onto the adjusting pins and slightly tighten (fig. B).

fig. B

3.Close the refrigerator door and check the height of the panel.

4.Adjust the height of the panel if necessary. Undo the securing nuts and use the adjusting pins to adjust (fig. C).

fig. C

GB

To make it possible to fasten the refrigerator panel at the bottom the soft-stop cylinder must be dismantled.

5.Stick a small screwdriver under the retaining clamp and lever out (fig. D).

fig. D

6.Grasp the soft-stop cylinder and pull down (Fig. E). The soft-stop cylinder retracts in the detached state.

fig. E

7.Transfer the lower edge of the attachment bracket onto the panel using a pencil. (fig. F). Remove the panel from the refrigerator door.

fig. F

19