Liebherr 7082 404-00, RB 1400, RBI 1400, EKB/es 4250 0406 manuel dutilisation Defrosting/Cleaning

DEFROSTING/CLEANING

Defrosting

The refrigerator compartment defrosts automati- cally. The defrost water is evaporated by the heat from the compressor; drops of water on the rear wall are perfectly normal.

WEnsure that the defrost water can flow freely through the drain hole in the rear wall (arrow in figure. A).

Cleaning

!WARNING

Always switch off the appliance, dis- connect the power cord or turn off the circuit breaker before cleaning.

Do not use steam cleaning equipment. Failure to follow these instructions may result in death or serious injury.

WClean the outer walls, inside and equipment by hand with lukewarm water and a little detergent.

WWe recommend using a soft cloth and an all-pur- pose cleaner with a neutral pH value. Only use food compatible cleaning and care agents on the inside of the appliance.

WUse a commercially available stainless-steel cleaning agent for stainless-steel appliances*.

-In order to achieve best possible protection, apply a stainless-steel care agent uniformly in grinding direction after cleaning. Points which are darker at the start and a more intensive coloration of the stainless-steel surface are normal.

-Do not use abrasive sponges or scourers, do not use concentrated cleaning agents and never use

cleaning agents containing sand, chloride or acid or chemical solvents, as these would damage the surfaces and could cause corrosion.

WEnsure that no cleaning water penetrates into the ventilation grilles or any electrical components, and

keep it out of the defrost drain as far as possible. Wipe the appliance dry.

- Do not damage or remove the type plate on the inside of the appliance. It is very important for servicing purposes.

WThe racks, shelves and other components should be cleaned by hand as they are not dishwasher-safe.

-Always remove the top door rack (butter and cheese compartment) together with the flap*. Then press one of the side walls carefully to the outside to release the flap pin. The flap can then be lifted out. Make sure not to damage any bushings*.

-The shelves and door racks can be dismantled for cleaning. Remove the trims and sides* from the

glass shelves.

WRemove the protective film* from the decorative trims.

W Clean the drain hole on the
rear wall frequently, figure.A,
arrow. If necessary, clean
with a thin object, e.g. a
cotton swab or similar.	Figure A

WTo clean the BioFresh drawers, pull the empty

drawers right out, grip at back and lift out (fig. L). - To re-insert: place the empty drawers on the ex- tended rails - the rails must align with the front of

the drawer - and slide in (figure M).

Figure L Figure M

-Simply pull the drawer cover out towards you. When re-inserting, make sure the bearing pins snap into place in the grooves.

The drawer and the cover must be flush with one another vertically.

WThe dust should be removed from the refrigeration unit

and heat exchanger - metal grid at the back of the ap- pliance - once a year. Dust deposits increase energy con- sumption.

WEnsure that none of the wires or other compo- nents are dislodged, bent or damaged.

WThen connect/switch on the appliance.

If the appliance is to be left switched off for any length of time, empty the appliance, disconnect the power supply, clean as described above and leave the door open so as to avoid odours.

* Depending on model and options

RBI/RB 1400 EKB/es 4250 11