STEP 17
•Screw one of the threaded ends of the previously removed HEAD PLATE CABLE approximately 1” into the end of the WEIGHT STACK SHAFT. See FIGURE17.
STEP 18
•Route the thread end of HEAD PLATE CABLE up and over the PULLEYS in the TOP BOOM above the WEIGHT STACK. (Remove pulleys for ease of installation.)
•Screw the other threaded end of the HEAD PLATE CABLE approximately 1” into the end of the shaft on the
FIGURE 17 |
|
HEAD PLATE |
|
CABLE |
|
(7041801) | WEIGHT STACK |
| |
| SHAFT |
•SECURELY tighten the pulleys connection from the previous step.
•Adjust out any slack in the two cable systems. (Refer to your 660101 instructions for the proper procedures.)
FIGURE 18 |
HEAD PLATE CABLE |
(67250) |
14 |
