Life Fitness 8210 manual Head Plate 34 should be on top

FIGURE 10

STEP 10

•Insert the two GUIDE RODS (15) into the base of the TOWER (6) as shown in FIGURE 10. Lubricate the GUIDE RODS (15) with a slicon or teflon spray that is available at most hardware stores.

•Slide two WEIGHT STACK CUSHIONS (37) down over the GUIDE RODS (15). See FIG- URE 10.

•Using EXTREME CARE slide twenty WEIGHT PLATES (36) down over the GUIDE RODS (15) with the key-hole facing as shown in FIGURE 10.

•Securely assemble the WEIGHT STACK SHAFT (33) to the HEAD PLATE (34) using one 3/8 X 1-1/4” BOLT (20) and one 3/8” WASHER (25). (Note: The bolt hole in the

HEAD PLATE (34) should be on top.)

•Carefully Slide the HEAD PLATE ASSEMBLY (33 & 34) down over the GUIDE RODS (15) onto the weight stack as shown in FIGURE 10.

•Slide two 13/16” SHAFT COLLARS (31) over the GUIDE RODS (15) as shown in FIGURE 10.

•Apply one set of WEIGHT STACK LABELS - LBS. OR 1-25 (40) (41) to each WEIGHT PLATE (36) as shown in FIGURE 10..

31

15

34

25

20 3/8 X 1-1/4”

33

36

40 41

37

6

9