Life Fitness 95LI

IMPORTANT!

DO NOT DISCARD THE SHIP KIT LOCATED ON TOP OF THE PEDALS. ALL NECESSARY COMPONENTS NEEDED TO

COMPLETE THE INSTALLATION ARE LOCATED IN THE SHIP KIT.

IMPORTANT!

NE JETEZ PAS LE KIT PLACÉ SUR LE DESSUS DES PÉDALE. IL CONTIENT TOUS LES ÉLÉMENTS

NÉCESSAIRES POUR L'INSTALLATION.

1. Open the top of the shipping carton.

2. Remove the documentation packet.

3. Remove the shipping sleeve.

4. Remove excess packaging. Knock down the sides of the

bottom tray and remove any corrugated shipping blocks.

5. Remove the HANDRAIL and set it aside.

6. Carefully cut the vertical bands securing the

MONOCOLUMN (A) assembly to the base pads.

7. Remove the tape, foam packaging and support block

located at the RECTANGULAR TUBE (B) and the

FRAME (C).

8. With the help of another person, carefully raise the

MONOCOLUMN (A) and insert the RECTANGULAR TUBE

(B) into the FRAME (C).

CAUTION: Do not pinch the WIRE HARNESSES or scratch

the paint when inserting the MONOCOLUMN into the

FRAME.

Secure the MONOCOLUMN to the FRAME using one

SCREW (5) and WASHER (6) from the front and two

SCREWS (5) and WASHERS (6) from the side. Tighten the

SCREWS to 20 –30 ft. lbs. Lower the HOUSING CAP (D).

9. Carefully cut the band securing the RIGHT CONTROL

LINK HUB (R) to the base pad. Lift the RIGHT CONTROL

LINK upward and align it onto RIGHT CONTROL LINK

SHAFT (S).

NOTE: Be sure the bearing within the RIGHT CONTROL

LINK HUB seats fully onto the stepped end of the RIGHT

CONTROL LINK SHAFT.

Secure the RIGHT CONTROL LINK HUB to the RIGHT

CONTROL LINK SHAFT using one SCREW (5) and

WASHER (30). Tighten the SCREWS to 20 –30 ft. lbs.

Install one ENDCAP (31) onto the RIGHT CONTROL LINK

HUB (E)

10. Repeat Step 9 to install the LEFT CONTROL LINK HUB.

11. Carefully tilt the unit upward from the rear and roll the unit

to the desired location for use.

12. Install the REAR STEP (2) using three BOLTS (1). Finger-

tighten the BOLTS.

13. Install the HANDRAIL UPRIGHTS (3) using one BOLT (4)

on each HANDRAIL UPRIGHT. Position the mounting

holes at the top of the HANDRAIL UPRIGHTS to face the

front of the unit. Tighten the BOLTS until snug.

SR30 531