14. Locate the CONSOLE BRACKET (7). Feed the
CONNECTORS (E & F) leading from the top of the
MONOCOLUMN (A) through the CONSOLE BRACKET as
shown.
Feed the HEART RATE CABLE CONNECTOR (G) marked
“LEFT”, located inside the MONOCOLUMN (A), outward
through the user left side hole of the MONOCOLUMN near
the BULLHORN MOUNTING BRACKET (H). Feed the
remaining HEART RATE CABLE CONNECTOR (J) through
the user right side hole of the MONOCOLUMN.
Feed the COAXIAL CABLE (K) and POWER CORD (L)
leading from the top of the MONOCOLUMN (A) through the
top of the CONSOLE BRACKET as shown. Secure the
CONSOLE BRACKET to the MONOCOLUMN using six
SCREWS (8). Tighten the SCREWS securely.
NOTE: If the entertainment option will not be used, carefully
gather the COAXIAL CABLE (K) and POWER CORD (L)
and insert them into the CONSOLE BRACKET.
15. Locate and insert the ACCESSORY TRAY (9) into the
MONOCOLUMN (A) as shown. Secure the ACCESSORY
TRAY to the CONSOLE BRACKET (7) using two SCREWS
(10). Tighten the SCREWS securely. Do not over tighten
the SCREWS.
16. Locate and position the DISPLAY CONSOLE (11) near the
ACCESSORY TRAY (9). Connect all CONNECTORS (E &
F) leading from the CONSOLE BRACKET (7) to the rear of
the DISPLAY CONSOLE. Mount the DISPLAY CONSOLE
using four SCREWS (12). Tighten the SCREWS securely.
Do not over tighten the SCREWS.
17. Locate and attach the CONSOLE SUPPORT COVER (13)
using two SCREWS (12). Tighten the SCREWS securely.
Do not over tighten the SCREWS.
18. Locate and install the CONSOLE SUPPORT CAP (14) . Be
sure the CONSOLE SUPPORT CAP snaps securely in
place.
19. Locate and install one GROMMET (15) in each square hole
between the yellow inserts in the BULLHORN MOUNTING
BRACKETS (H).
20. Locate the HANDRAIL (16). Position the rear tubes of the
HANDRAIL over the HANDRAIL UPRIGHTS (3) and lower
the HANDRAIL onto the HANDRAIL UPRIGHTS. Carefully
rest the front of the HANDRAIL against the
MONOCOLUMN (A). Secure the HANDRAIL to the
HANDRAIL UPRIGHTS using four SCREWS (17). Tighten
the SCREWS securely.
21. Locate the LEFT and RIGHT BACK BULLHORN COVERS
(18 & 19). Place the BACK BULLHORN COVERS between
the HANDRAIL (16) and BULLHORN MOUNTING
BRACKETS (H) as shown. Route the HEART RATE
WIRES (M) from the HANDRAIL downward inside the
BACK BULLHORN COVERS and to the front of the unit.
Connect the HEART RATE WIRES to those leading from
the front of the MONOCOLUMN. Be sure the
CONNECTORS are fully seated.
22. Secure the front of the HANDRAIL (16) to the BULLHORN
MOUNTING BRACKETS using four SCREWS (20). Tighten
the SCREWS securely.
K L
11
9
F
E
7
14
12
13
8
10
A
J
H
G
16
317
20
18
H
15 M
19