Light & Motion manual Changing D100 Lenses, Attaching Light & Motion Ports / Conversion Rings

+

LR

OFF

Press these buttons to

increase or decrease strobe power.

(Fig. 40)

+

LR

OFF

Press and hold to deactiveate strobe(s).

(Fig. 42)

SUB

+ +

SUB

FOCUS

LED will blink four times when switching to AEL-AFL mode.

(Fig. 44)

SUB
+	+
SUB

FOCUS

To change focus zones: First Press and hold the Focus button.

+

LR

OFF

Press strobe select button to adjust strobes together or independently.

(Fig. 41)

SUB

+ +

SUB

FOCUS

Press and hold both buttons to enter “AEL-AFL” mode.

(Fig. 43)

(Fig. 45)

SUB
+	+
SUB

FOCUS

Then press the “Sub -” button to change focus zones.

Using ROC for area focus select

This feature requires the Focus button to be set up in the AE-L / AF-L function outlined in the previous section.

1.Press and hold the Focus button (Fig. 46).

2.While holding the Focus button press the Sub - button (Fig. 47). You will see the focus area highlighted in the view finder.

3.Continue holding the Focus button and pressing the Sub - button to scroll through the focus zones of the camera.

Changing D100 Lenses

The Titan D100 has a lens release mechanism that allows you to change camera lenses with the camera inside the Titan housing.

1.Remove the Titan port.

2.Press the lens release lever that extends to the camera’s lens release button.

3.Continue holding the lever and turn the lens clockwise to remove it.

Attaching Light & Motion Ports / Conversion Rings

To Install Lens / Conversion Ring

1.Inspect O-rings for serviceability.

2.Align bayonet details on lens/ring to bayonet details on housing.

3.Press lens/ring into housing and ensure the entire mating surfaces are flush (Fig. 49).

4.Rotate clockwise until locking pin engages (Fig. 50).

To Remove Lens / Conversion Ring

1.Slide locking pin away from lens/ring (Fig 48).

2.Rotate lens/ring counter clockwise until port/ring stops.

3.Pull away from housing.

Attaching Light & Motion Lens gears

Refer to the instructions that were packaged with your gear set for gear installation.

Light & Motion ports and gears are made for Nikon Lenses. The following lenses are suported; 14mm, 16mm, 18mm, 20mm, 24mm, 17-35mm, 60mm, 105mm and 12-24 DX.

(Fig. 46) (Fig. 47)