INSTRUCTIONS FOR 6.5” PENDALYTE™ SERIES TRACK MOUNT TO LYTESPAN ® TRACK SYSTEM SUSPENSION
KITS. FOR USE WITH LYTESPAN TRACK SYSTEMS ONLY.
CAUTION: MAXIMUM WATTAGE AS MARKED ON LUMINAIRE MUST NOT BE EXCEEDED.
#4 SCREWS
BODY
BRASS CONTACT
NICKEL CONTACT
CONTACT
SCREWS
SET SCREW
BUSHING
POWER STEM INSTALLATION (fig. 1)
1.Slide STEM and BUSHING over POWERCORD. Align end of POWERCORD with top of BUSHING tighten SET SCREW to secure
POWERCORD.
2.Twist stripped ends of POWERCORD wires an attach using CONTACT SCREWS: attach hot (black POWERCORD lead to long BRASS CONTACT, attach neutral (white) POWERCORD lead to short NICKEL CONTACT, attach POWERCORD ground lead (green) to BODY with green CONTACT SCREW.
3.Slide STEM up over contacts and secure to BODY using #4 SCREWS.
TRACK
BEAD | STEM LEVER |
|
Fig. 2
STEM
POWERCORD
Fig. 1
NOTE: Not for use with ProSpec track.
WARNING: TO PREVENT ELECTRIC
SHOCK, TURN OFF POWER TO TRACK.
INSTALLATION INTO TRACK (fig. 2)
1.Turn off power to TRACK.
2.Insert POWER STEM into track. The STEM LEVER must be on the same side as the track bead. See fig. 2.
3.Rotate suspension stem 90° clockwise using STEM LEVER. STEM LEVER should be parallel to TRACK.
4.To remove: rotate SUSPENSION STEM 90° counterclockwise using
