8 5 0 i R | U s e r | M a n u a l |
TROUBLESHOOTING GUIDE |
| ||
Note: Most problems are directly related to low battery power. Please run | |||
through the “Battery Check” items first. For remaining troubleshooting, | |||
use known good, |
|
| |
Battery Check | No Sound From Speaker | ||
• | Confirm batteries are charged | • | Turn the 850iR on. Confirm that |
| each night. |
| the POWER light located on the |
• | Make sure the |
| front panel switch is on. |
|
| ||
| while charging so that it will attain | • | Confirm signal is being received |
| a full charge. Full charge will last |
| at the amplifier. The IR signal |
| eight hours. |
| light will be lit (red) indicating a |
• | Make sure the charge cord is |
| signal is being received. |
|
| ||
| connected to the cradle charger. | • | Confirm microphone is function- |
• | Inspect the battery contacts. Clean |
| ing. Next to the IR signal light is |
| the AF signal light. This light will | ||
| and adjust if necessary. |
| |
|
| flicker (green) as audio is picked | |
Hearing Static |
| ||
| up by the microphone indicating | ||
• | Ensure sensor is in optimum |
| activity. |
|
| ||
| location (refer to sensor placement | • | Ensure speaker switch on the |
| in manual). A single sensor will |
| amplifier is in the “ON” position |
| cover a 1600 sq. ft. enclosed |
| for each speaker that is connect- |
| classroom. |
| ed to the amplifier. Check con- |
• | Ensure that no other LT71/HM70 is |
| nections on both the amplifier |
| and speaker. | ||
| operating on the same channel. |
| |
|
|
| |
• | If an external microphone is in use, | • | Confirm that the speaker wires |
| are connected correctly to the | ||
| try another LightMic that is known |
| |
|
| back of the 850iR (refer to | |
| to be working (if available) to isolate |
| |
|
| speaker install guide) and make | |
| the problem. If static persists with |
| |
|
| sure that the speaker switch for | |
| “known good” microphone, the |
| |
|
| that output jack is in the ON | |
|
| ||
|
| position. | |
| will need service. |
| |
|
|
| |
Low Volume or Feedback |
|
|
•Ensure microphone is positioned appropriately, just below the collar bone. If a headset microphone is in use, the end of the mic boom should be positioned at the corner of the mouth.
•Check volume level on the ampli- fier. If the volume is too high, feed- back WILL
If you review these instructions and still have questions, write down the serial number and model number of your system and call LightSPEED Technical Services at 800.732.8999, 6:30 a.m. – 5 p.m. PST.