WARNING
ELECTRIC
SHOCK
CAN KILL
Turn off input power to the Welding Power Source
using the disconnect switch at the fuse box
Before connecting the wire feeder.
Only qualified persons should install, use or
service this machine.
14 PIN | OPTIONAL K857 | ||
REMOTE CONTROL | |||
POWER SOURCE | AMPHENOL | ||
| |||
|
|
N.C.
+ | - |
| OPTIONAL | K864 | REMOTE |
|
| CONTROL | ADAPTER |
| |||
CV- |
| OPTIONAL |
| |||
250 |
| K484 | JUMPER |
| WIRE | FEEDER |
| PLUG |
|
| |||
|
| N.D. |
|
|
|
|
| TO | WORK |
|
|
|
|
ELECTRODE CABLE
N.A. WELDING CABLE MUST BE SIZED FOR CURRENT AND DUTY CYCLE OF APPLICATION. N.B. DIAGRAM SHOWS ELECTRODE POSITIVE. TO CHANGE POLARITY, TURN POWER "OFF",
REVERSE ELECTRODE AND WORK CABLES AT POWER SOURCE.
N.C. USE OF THE K857 REMOTE CONTROL REQUIRES INSTALLATION OF A K864 REMOTE CONTROL ADAPTER TO THE 14 PIN AMPHENOL OF THE POWER SOURCE.
N.D. CONNECT THE K484 JUMPER PLUG DIRECTLY TO THE 14 PIN AMPHENOL
OF THE POWER SOURCE IF NO REMOTE CONTROL IS USED.
IF USING A K857 REMOTE CONTROL,CONNECT THE K484 JUMPER PLUG
TO THE 14 PIN AMPHENOL OF THE K864 REMOTE CONTROL ADAPTER.
THE POWER SOURCE WELDING TERMINALS ARE ALWAYS "HOT" WHEN THE K484 JUMPER
S20661
