Lincoln Electric IM10041 manual Engine Welders / K867 / LN-8 Connection Diagram

AIR VANTAGE® 500 CUMMINS

ENGINE WELDERS / K867 / LN-8 CONNECTION DIAGRAM

WARNING

	Do not operate with panels open.		Keep guards in place.
	Disconnect NEGATIVE (-) BATTERY LEAD		Keep away from moving parts.
	before servicing.	42	Only qualified personnel should install,use
	Do not touch electrically live parts.		}
			or service this equipment.
		SPARE
		82			LN-8
		81	N.C.		WIRE
					FEEDER
		41
		31		31
	14 PIN	32		32
	AMPHENOL	2		2
		4		4	K196
ELECTRODE	TO WORK	21		21
	K867 UNIVERSAL	GND		GND	INPUT CABLE
	ADAPTER PLUG
	TO WORK	75		A
	ELECTRODE CABLE	76		B
		77
CAUTION :	TO WIRE FEED UNIT		}	C
			N.D.

ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE WILL CAUSE

AN INCREASE IN THE THE AC AUXILIARY VOLTAGE. IF THIS VOLTAGE GOES OVER 140 VOLTS, WIRE FEEDER CONTROL CIRCUITS MAY BE

DAMAGED. THE ENGINE GOVERNOR SETTING IS PRE-SET AT THE FACTORY - DO NOT ADJUST ABOVE RPM SPECIFICATIONS LISTED IN

THE ENGINE WELDER OPERATING MANUAL.

N.A. WELDING CABLE MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE

APPICATIONS. SEE OPERATING MANUAL.

N.B. USE VOLTMETER SWITCH TO SELECT DESIRED ELECTRODE POLARITY. POSITION THE SELECTOR SWITCH TO "WIRE WELDING CV".

N.C. INSULATE EACH UNUSED LEAD INDIVIDUALLY.

N.D. SPLICE LEADS AND INSULATE.

7-2000

S23989

F-6

DIAGRAMS

F-6