![](/images/new-backgrounds/1327866/32786641x1.webp)
OPERATION | ||
|
|
|
Wire Feed Speed Units
To change the wire feed speed units:
Rotate the WFS knob to |
| |||
the | left | to | use |
|
“inches/minute” for the |
| |||
wire feed speed units. | US |
| ||
O O A | V | |||
|
|
| ||
|
|
| O O WFS |
|
To change the
Rotate the WFS knob to the left to turn
Rotate the WFS knob to the right to turn
r
u
n
OF
F
O O | A | V |
O O WFS
Rotate the WFS knob to the right to use “meters/minute” for the wire feed speed units.
Then rotate the WFS knob to the 12 oʼclock position.
EU
r
o
O O | A | V |
O O WFS
| r u n | On |
Then rotate the WFS knob | O O A | V |
|
| |
to the 12 oʼclock position. | IRONWORKER | |
|
| |
| O O WFS |
|
Press the
again to enter the WFS calibration menu.
Press the
RUN-IN
When
Model |
|
Extra Torque Models | 25 in/min |
Standard Speed Models | 50 in/min |
|
|
When
WFS CALIBRATION
Measurements for adjusting the WFS calibration must be made before entering the
While in the
Actual WFS | =Calibration Factor Example | 405 | =1.01 |
Set WFS | 400 |
Press the