MAINTENANCE
To service the pre-cleaner:
Remove the wing nuts and cover for Codes 10158, 10160)
Remove the cover for (Codes 11183, 11406). Carefully remove the foam
1.Wash in liquid detergent and water.
2.Squeeze dry in a clean cloth.
3.Saturate in clean engine oil.
4.Squeeze in a clean, absorbent cloth to remove all excess oil.
Carefully place the
CLEAN ENGINE: Remove dirt and debris with a cloth or a brush. Do not clean with a forceful spray of water. Water might contaminate the fuel system. Use low pressure air to blow out the machine periodically. In particularly dirty locations this may be required once a week.
WARNING
Engine Adjustments
OVERSPEED IS HAZARDOUS - The maximum allowable high idle speed for this machine is 3750 RPM, no load. Do NOT tamper with the governor components or setting or make any other adjustments to increase the maximum speed. Severe personal injury and damage to the machine can result if operated at speeds above maximum.
Adjustments to the engine are to be made only by a Lincoln Service Center or an authorize Field Service Shop.
Slip Rings
A slight amount of darkening and wear of the slip rings and brushes is normal. Brushes should be inspected
CAUTION
when a general overhaul is necessary. If brushes are to be replace, clean slip rings with a fine emery paper. Do not attempt to polish slip rings while engine is running.
Hardware
Both English and Metric fasteners are used in this welder.
Engine Maintenance Parts
(For Codes 10158, 10160)
|
|
| B & S Vanguard® 9 HP | |
Air Filter Element |
| B & S 710266 | ||
Air Filter |
| B & S 710268 |
| |
Spark Plugs |
| B & S 491055 | ||
(Resistor Type) |
| Champion RC12YC | ||
|
|
| Autolite 3924 | |
|
|
| (Gap .030” [.76mm]) | |
|
|
|
| |
(For Codes 11183, 11406) |
|
| ||
|
|
| Robin / Subaru | |
Air Filter Element |
|
| ||
Air Filter |
|
| ||
Spark Plug |
| NGK BR6 HS | ||
(Resistor Type) |
| (Gap .030” [.76mm]) | ||
|
|
|
|
|
– 20 – | WELDANPOWER 125 |
