INSTALLATION
STACKING
Weldanpower 125 machines CANNOT be stacked.
TILTING
Place the machine on a secure, level surface whenever you use it or store it. Any surfaces you place it on other than the ground must be firm, non- skid, and structurally sound.
The gasoline engine is designed to run in a level position for best performance. It can operate at an angle, but this should never be more than 15 degrees in any direction. If you do operate it at a slight angle, be sure to check the oil regularly and keep the oil level full. Also, fuel capacity will be a little less at an angle.
Oil
The Weldanpower 125 is shipped with the engine filled with SAE 10W30 oil. CHECK THE OIL LEVEL BEFORE YOU START THE ENGINE. This is an added precaution. Do not screw in dipstick when checking oil level. DO NOT OVERFILL. Be sure the fill plug is tight after servicing.
Fuel
Fill the fuel tank with clean, fresh, regular grade (minimum 85 octane for codes 10158, 10160 and 87 octane for codes 11183, 11406) lead free gasoline. DO NOT MIX OIL WITH GAS. The Weldanpower 125 capacity is approximately 1.6 gallons (6.1 Liter). DO NOT OVERFILL, allow room in the fuel tank for fuel expansion.
Spark Arrester
LIFTING
(For Codes 10158, 10160)
The Weldanpower 125 should be lifted by two people. (See Specification section for weight). Its welded tube roll cage is designed to make lifting easier.
PRE-OPERATION ENGINE SERVICE
Some federal, state or local laws may require gasoline engines to be equipped with exhaust spark arresters when they are operated in certain locations where unarrested sparks may present a fire hazard. The standard mufflers & deflectors included with this
Read and understand the engine operating and
maintenance instructions supplied with this machine
before you operate the Weldanpower 125.
WARNING
•Keep hands away from muffler or HOT engine parts.
•Stop the engine when fueling.
•Do not smoke when fueling.
•Remove fuel cap slowly to release pressure.
•Do not overfill tank.
•Wipe up spilled fuel and allow fumes to clear before starting engine.
•Keep sparks and flame away from tank.
WELDANPOWER 125 | – 3 – |
machine do not qualify as spark arresters. When required by local regulations, a suitable spark arrester (available from Briggs & Stratton) must be installed and properly maintained.
(For Code 11183, 11406)
Some federal, state or local laws may require gasoline engines to be equipped with exhaust spark arresters when they are operated in certain locations where unarrested sparks may present a fire hazard. The standard muffler included with this machine does qualify as a spark arrester.
CAUTION
An incorrect additional arrester may lead to damage to the engine or adversely affect performance.
