MAINTENANCE | ||
|
|
|
SAFETY PRECAUTIONS
WARNING
•Have a qualified technician do the maintenance and troubleshooting work.
•Turn the engine off before working inside the machine.
•Remove guards only when necessary and replace them when the maintenance requiring their removal is complete.
•Always use the greatest care when working near moving parts.
Read the Safety Precautions in front of this manual and the engine instruction manual before working on this machine.
Keep all equipment safety guards, covers and devices in position and in good repair. Keep hands, hair, cloth- ing and tools away from
ROUTINE AND PERIODIC
MAINTENANCE
DAILY
a. Check the crankcase oil level .
b. Refill the fuel tank to minimize moisture condensa- tion in the tank.
c. Open the water drain valve located on the bottom of the water separator element 1 or 2 turns and allow to drain into a container suitable for diesel fuel for 2 to 3 seconds. Repeat the above drainage procedure until diesel fuel is detected in the container.
WEEKLY
Blow out the machine with low pressure air periodical- ly. In particularly dirty locations, this may be required once a week.
ENGINE MAINTENANCE
Refer to the “Periodic Checks” section of the Engine Operator’s Manual for the recommended maintenance schedule of the following:
a)Engine Oil and Filter
b)Air Cleaner
c)Fuel Filter - and Delivery System
d)Cooling Blower Belt
e)Battery
f)Cooling System
Refer to Table D.1 at the end of this section for various engine maintenance components.
AIR FILTER
CAUTION
EXCESSIVE AIR FILTER RESTRICTION WILL RESULT IN REDUCED ENGINE LIFE.
1.Service air cleaner regularly according to Engine Operator's Manual.
2.Stop engine after 100 hours of running time and clean filter element, replace the filter if necessary.
The air filter canister is located behind the engine door on top of the air intake box.
The air filter element is a dry cartridge type. It can be cleaned and reused; however, damaged elements should not be reused. Remove loose dirt from element with compressed air or water hose directed from inside out. Compressed Air: 100 psi maximum with nozzles at least one inch away from element. Water Hose: 40 psi maximum without nozzle.
Soak element in a mild detergent solution for 15 min- utes. Do not soak more than 24 hours. Swish element around in the solution to help remove dirt. Rinse ele- ments from inside out with a gentle stream of water (less than 40 psi) to remove all suds and dirt. Dry ele- ment before reuse with warm air at less than 1600F (710C). Do not use a light bulb to dry the element.
Inspect for holes and tears by looking through the ele- ment toward a bright light. Check for damaged gaskets or dented metal parts. Do not reuse damaged ele- ments. Protect element from dust and damage during drying and storage.
Replace air filter after six cleanings. A cleaned filter will have approximately 70% of the life of a new filter element. A restricted filter element may not appear excessively dirty.
