Lincoln Electric IM601-A manual Installation Instructions

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿C￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿"#￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

INSTALLATION INSTRUCTIONS

CONNECTION F-9

1.REPLACE EXISTING BRACKET ON ADAPTER KIT ASSEMBLY WITH THE ADAPTER BRACKET THAT HAS A HALF INCH SQUARE HOLE IN IT.

2.REMOVE THE THREE SCREWS SHOWN AND USE THEM TO FASTEN THE ADAPTER KIT ASSEMBLY ONTO THE WELDER.

SCREWS

WARNING
￿7￿479￿7,+0/9+￿?39:￿,/4+52￿7,+4￿	￿++,￿-.￿,5/6+￿34￿/012
￿326744+69￿￿￿￿￿￿￿%￿￿￿"￿￿￿￿￿￿￿￿&￿￿￿￿￿	<7834￿A07<￿/?/@￿++,￿-￿,/092￿
B+A70+￿2+083634-￿	;￿45@￿.2:7￿,+02744+5￿/53A3+1.3429/55(￿51.2+
￿7￿479￿97.6:￿+5+69036/55@￿538+￿,/092￿	+;￿9:32￿2+0836+￿70.￿3,<+49

COMMANDER 300

ENGINE WELDER WITH		ENGINE WELDER
115 VAC AUXILIARY
		14 PIN AMPHENOL
		9 CONDUCTOR ADAPTER CABLE
									K350-1
ELECTRODE	TO
	WORK
						LN-23P ADAPTER KIT
			FEEDER "A"						FEEDER "B"
		602	604	75	76	77	521	602	604	75	76	77

N.A.	N.B.
LN-23P	LN-23P

WORK

521

OPERATING INSRTUCTIONS

N.A. WELDING CABLES MUST BE OF PROPER CAPACITY FOR THE CURRENT AND THE DUTY CYCLE OF IMMEDIATE AND FUTURE APPLICATIONS. SEE OPERATING MANUAL FOR PROPER SIZES.

N.B. IF ONLY ONE LN-23P IS USED, CONNECT TO FEEDER "A" TERMINAL STRIP IN ADAPTER.

N.C. USE VOLTMETER SWITCH TO SELECT DESIRED ELECTRODE POLARITY. POSITION THE SELECTOR SWITCH TO "WIRE WELDING CV".

N.D. IF REMOTE OUTPUT CONTROL IS USED, PLACE LOCAL/REMOTE SWITCH IN "REMOTE" POSITION.

N.E THE OUTPUT CONTROL SWITCH MUST BE IN THE "WELDING TERMINALS REMOTELY CONTROLLED" POSITION.

CAUTION: WHEN MOUNTING ADAPTER TO WELDER, SPECIAL CARE IS TO BE TAKEN AS NOT TO DAMAGE ANY MACHINE COMPONENTS, SUCH AS/BUT NOT LIMITED TO ELECTRICAL COMPONENTS, WIRES OR FUEL TANKS.

DIAGRAMS

ELECTRODE WIRE FEEDER "A" ELECTRODE WIRE FEEDER "B"

4-3-98F

M17866

F-9