2. Plasma will only cut conductive material. Do not attempt to cut fiberglass, plastic, rubber, PVC or any other non-conductive material.
3. Make sure work piece is clean and dry. Remove any scale, rust or dross.
4. Check all connections to Output If all recommended possible areas of
board.misadjustment have been checked and the problem persists, Contact
5. Possible faulty Control board. your local Lincoln Authorized
Field Service Facility.
CAUTION
If for any reason you do not understand the test procedures or are unable to perform the tests/repairs safely, contact your Local Lincoln Authorized Field Service Facility for technical troubleshooting assistance before you proceed.
1. Check work lead connection for clean, secure connection.
Pilot arc starts but will not transfer when brought near work.
|
| TROUBLESHOOTING |
| ||
|
|
|
|
|
|
| Observe all Safety Guidelines detailed throughout this manual | ||||
|
|
|
|
|
|
| PROBLEMS | POSSIBLE |
| RECOMMENDED | |
| (SYMPTOMS) | CAUSE | COURSE OF ACTION | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
