INSTALLATION |
Remove the connector nut from the INLET hose by making a straight cut 6-12mm(1/4"-1/2") away from the end of the nipple located inside of the hose. Take the nipple and the connector nut ordered above and insert the nipple into the connector nut so that the threaded end of the connector nut points away from the barbed end of the nipple. Twist the barbed end of the nipple into the hose until the shoulder of the nip- ple is flush with the end of the hose. Secure the hose onto the nipple with the hose clamp to insure that the connection is watertight. No water can leak from the connection if it is properly attached. Repeat the proce- dure for the OUTLET hose. When complete, follow the connection procedure detailed above for connecting the hoses to the COOL ARC® 40 fittings.
The connector and nipple listed fit tightly onto 4.0 mm (5/32") to 4.8mm(3/16") inner diameter hose, but if clamped tightly to the hose, can fit up to a 6.4mm(.25”) inner diameter hose.
INPUT POWER CONNECTION
Plug the input power cord on the COOL ARC® 40 into a standard 230V circuit breaker protected receptacle.
INSTALLATION ON UNDERCARRIAGE OR POWER SOURCE
The COOL ARC® 40 can be mounted either horizon- tally or vertically on a power source. To mount the cooler horizontally, order the
HORIZONTAL INSTALLATION ON THE TOP OF A POWER SOURCE
For proper installation, follow the instructions provided with the
VERTICAL INSTALLATION ON POWER SOURCE WITH A DUAL CYLINDER UNDERCARRIAGE.
For proper installation, follow the instructions provided with the
WARNING
If the COOL ARC® 40 is not securely mounted horizontally on top of a power source or vertically on a dual cylinder undercarriage.
THE
| ||
| Cooler Vertical Mounting | Cooler Horizontal |
Power Source | Bracket on a Dual | Mounting Bracket |
| Cylinder Undercarriage | Can be used On Top |
|
| of a Power Source |
K874 Undercarriage | Yes | |
Not Available | Yes | |
Not Available | Yes | |
Not Available | Yes | |
Not Available | Yes | |
Not Available | Yes | |
Square Wave TIG 275 | No | |
Square Wave TIG 355 | Not Available | Yes |
Power Wave 455 | No | |
Power MIG 255 | Not Available | No |
|
|
|
COOL ARC® 40