Lincoln Electric IM690-A manual DIP Switch Settings and Locations

A-10 INSTALLATION A-10

DIP Switch Settings and Locations

DIP switches on the P.C. Boards allow for custom configuration of the Power Wave. To access the DIP switches:

WARNING

•Turn off power at the disconnect switch.

------------------------------------------------------------------------

•Remove the top four screws securing the front access panel.

•Loosen, but do not completely remove, the bottom two screws holding the access panel.

•Open the access panel, allowing the weight of the panel to be carried by the bottom two screws. Make sure to prevent the weight of the access panel from hanging on the harness.

•Adjust the DIP switches as necessary.

•Replace the panel and screws, and restore power.

Control Board Feed Head Board

Left Right

DeviceNET/Gateway Board

Control Board DIP Switch:

switch 1 = Object Instance LSB1 (see table 1)

switch 2 = Object Instance MSB2 (see table 1) switch 3 = Equipment Group 1 Select switch 4 = Equipment Group 2 Select switch 5 = Equipment Group 3 Select switch 6 = Equipment Group 4 Select switch 7 = reserved for future use

switch 8 = work sense lead

1LEASE SIGNIFICANT BIT

2MOST SIGNIFICANT BIT

switch 8 work sense lead

off	work sense lead not connected
on	work sense lead connected

Feed Head Board DIP Switch:

switch 1 = Object Instance LSB (see table 1) switch 2 = Object Instance MSB (see table 1) switch 3 = Equipment Group 1 Select switch 4 = Equipment Group 2 Select switch 5 = Equipment Group 3 Select switch 6 = Equipment Group 4 Select switch 7 = negative polarity switch

	switch 7	electrode polarity
	off	positive (default)
	on	negative
switch 8 = high speed gear
	switch 8	wire drive gear
	off	low speed gear (default)
	on	high speed gear

DeviceNET/Gateway Board DIP Switch:

Bank (S1):

switch 1 = Object Instance LSB (see table1) switch 2 = Object Instance MSB (see table 1) switch 3 = Equipment Group 1 Select switch 4 = Equipment Group 2 Select switch 5 = Equipment Group 3 Select switch 6 = Equipment Group 4 Select switch 7 = Reserved for future use

switch 8 = Reserved for future use

TABLE 1

Object Instance

switch 2	switch 1	Instance
off	off	0 (default)
off	on	1
on	off	2
on	on	3

POWER WAVE 455/R