INSTALLATION | ||
|
|
|
GENERAL INSTALLATION REQUIREMENTS
LOCATION
Locate the Demo Zone on a flat surface. The Demo Zone is intended for indoor use only. The Demo Zone must be sheltered from rain and water.
ENGINE EXHAUST
CAUTION
Provide an exhaust capability for the Ranger 250 machine. Flexible metal exhaust hose, available from automobile parts stores, should be used to exhaust gasses to the outdoors. The exhaust pipe on the Ranger 250 is 1.5" diameter nominal. Use a clamp at the muffler to ensure a good seal.
The exhaust pipe and flexible metal exhaust hose is hot! Do not touch when hot. Keep flammable material away from the exhaust hose. Place a "Hot
-Do not touch" sign near the hose to warn of the hazard.
Ensure that there is sufficient fresh air and venti- lation available during operation of the Ranger 250.
WELDING SMOKE AND FUME
Provide an exhaust for welding smoke and fume.
STACKING
The Demo Zone is not designed for stacking.
HANDLING
A pallet jack or forklift truck can be used to move the Demo Zone and to install the caster kit. The place- ment of the pallet jack or forks must balance the Demo Zone load to prevent tipping.
WARNING
FALLING EQUIPMENT can cause injury.
• Do not lift the Demo Zone by over- head crane.
•Do not lift the Demo Zone with gas cylinder in place.
•Lift from front of Demo Zone only. Do not lift from left, right or rear sides.
The Demo Zone is too heavy for one person to move by hand on an inclined surface. Avoid situa- tions that may injure yourself or others.
DEMO ZONE
