Lincoln Electric SP-135T manual Safety Precautions, Identify and Locate Components

A-2 INSTALLATION A-2

Read entire installation section before starting installation.

SAFETY PRECAUTIONS

WARNING

ELECTRIC SHOCK can kill.

•Only qualified personnel should perform this installation.

•Only personnel that have read and under- stood the SP-135T Operating Manual should install and operate this equipment.

•Machine must be plugged into a receptacle which is grounded per any national, local or other applicable electrical codes.

•The SP-135T power switch is to be in the OFF (“O”) position when installing work cable and gun and when connecting power cord to input power.

IDENTIFY AND LOCATE

COMPONENTS

If you have not already done so, unpack the SP-135T from its carton and remove all packing material around the SP-135T. Remove the following loose items from the carton (see Figure A.1):

1.SP-135T

2.Gun and cable assembly(1)

3.Literature and miscellaneous including:

a)This operating manual

b)6 extra .023"-.025” (0.6 mm) contact tips

c)Hex key wrench for removal of drive roll.

4.10 ft (3.0 m) work cable.

5.Work clamp.

6.2 LB. Sample Spool of Super Arc L-56 .025 MIG Wire.

7.Handshield with filter plate and lens.

8.Adjustable mixed-Gas Regulator & Hose.

For available options and accessories refer to the Accessories Section of this manual.

1)As shipped from the factory, the SP-135T gun liner is ready to feed .023” (0.6 mm) -.035 (0.9 mm) wire. The contact tip is sized for .023”-.025” (0.6 mm) wire feeding.

FIGURE A.1

2

1

4

6

3

5

8

7

SP-135T