Lincoln Electric SVM199-A Memory Selections, Welding Process Modes Available, Electrode Material

TOC

TOC

B-6 OPERATION B-6

MEMORY SELECTIONS:

(See Figure B.2 for location of controls)

Return to Section

Return to Section TOC

Return to Section TOC

Return to Section TOC

Return to Master

Return to Master TOC

Return to Master TOC

Return to Master TOC

The MEMORY button and SELECT knob are used together to select a welding process and store it in memory (M1 thru M8). The SELECT knob scrolls through the welding process modes and memory M1 thru M8. The MEMORY button stores the welding process in memory.

•SELECT button" (The right button) selects between the "Hot Start" or "Arc Control". The < will indicate the active feature shown below.

Right Digital Window

"Hot Start" (-10 to 0 +10) "Arc Control" (0 to 10) <

•The ADJUST knob adjusts the desired settings for the Hot Start or Arc Control feature that is active.

WELDING PROCESS MODES AVAILABLE

Stick SMAW, TIG GTAW

Gouge CAG, CV MIG GMAW

CV Flux Core, Pulse MIG

ELECTRODE MATERIAL

Steel, Metal Core, Stainless, Aluminum, Nickel

EXAMPLE OF SAVING WELDING MODES TO MEM- ORY

The following example is how to select Pulse MIG using .035 steel and store it into memory.

1.Turn the SELECT knob until welding process is dis- played.

RIGHT WINDOW	LEFT WINDOW
Pulse MIG	Argon Blends
Steel .035

2.Wait two seconds and the right window will display Arc Control on the second line on the right side.

Pulse MIG	Argon Blends
Steel .035	Arc Cntrl ### <

3.SPd is displayed in the upper right Volts window. The left Amps window matches the desired wire feed speed that is set on the wire feeder. Adjust the OUTPUT knob until desired number is displayed.

4.Start welding. If the arc length is too short, turn the Output knob up. If the arc length is too long, turn the Output knob down.

The Arc Control, which is displayed in the right digi- tal window, can be used to fine-tune the arc length and characteristics.

5.After all adjustments have been made press and hold the MEMORY button until the display changes. The right and the left window will display a memory position, for example M1 (or turn knob to select memory of your choice). To store in M1, push the MEMORY button again to save the Pulse Mig mode to memory M1.

6.The display in the digital windows read as follows:

M1 Pulse MIG	Argon Blends
Steel .035	Arc Cntrl 1.2

7.To save a second welding mode to a memory posi- tion of your choice, turn the SELECT knob until the desired welding process mode is displayed in right digital window. Then follow steps 2 thru 6.

8.Adjust the output control to the correct wire feed set- ting and the V450-PRO is ready to weld again. (NOTE: The wire feed speed setting is not stored in memory and will need to be reset.)

9.Adjust the Arc Control and note that the M1 goes away indicating that the V450-PRO settings no longer match what is stored in memory. Going back to the original settings will not bring the M1 back. You will need to push the MEMORY button to recall the original settings in M1.

NOTE: After all memory; M1 thru M8, are used and the welder needs to store another welding process, a new welding process will overwrite what was originally in the memory and will read:

Save to MEM M1 Overwrite

M1, which previously stored Pulse Mig, is now over- written with the new welding process.

INVERTEC® V450-PRO