Linear AE-2000 Important Mounting Requirements, Mounting Environment, Follow Building Codes

Important Mounting Requirements

The AE-2000 Telephone Entry System can be installed for public or private use. The mounting requirements will vary depending on the installation. Review the following information before beginning the installation.

Mounting Environment

Consider the environmental factors at the desired mounting location. The AE-2000 is designed for direct outdoor installations, however, it is preferable to protect the unit from extreme exposure to sun, driving rain, or snow whenever possible. Mounting the unit in a kiosk can provide extra environmental protection.

Follow Building Codes

Check all local building codes and ordinances prior to installing the	?
system. Proper installation of the AE-2000 conforming to the local
building codes for access control equipment is a regulatory requirement.	?
The AE-2000 installation is an extremely important and integral part of
the overall access control system.	?

Mounting Location

If the AE-2000 is used to control a door or pedestrian gate, locate the unit as near as practical to the entry point. If the unit is mounted on or in a wall adjacent to the entry point, be sure the wall is sturdy. The repeated shock and vibration from a slamming access door or spring-loaded pedestrian gate must be isolated from the AE-2000. NEVER MOUNT THE UNIT

DIRECTLY TO A MOVING DOOR OR GATE!

Gate Installations

If the AE-2000 is used to control a gate operator connected to a vehicular
gate, the unit MUST be mounted AT LEAST 10 feet away from the gate
(open and closed) and gate operator. AT NO TIME SHOULD A PERSON
BE ABLE TO TOUCH THE GATE OR GATE OPERATOR AND THE	10 FEET
AE-2000 AT THE SAME TIME.	MINIMUM

Vehicle Traffic

Do not mount the AE-2000 where it extends into any traffic lane. Locate the gooseneck pedestal or entry kiosk so all parts of the AE-2000 are outside the traffic lane. Locate the AE-2000 clear of any turn-around lanes vehicles use when access is denied.

Americans with Disability Act (A.D.A.) Requirements

THE FOLLOWING WHEELCHAIR ACCESS REQUIREMENTS ARE

FOR PUBLIC DOOR CONTROL INSTALLATIONS ONLY.

1.If the clear floor space allows only forward approach to the system, the maximum high forward reach allowed is 48” above grade to the top of the keypad.

2.If the high forward reach to the system is over an obstruction of greater than 20” but less than 25”, the maximum high forward reach allowed is 44” above grade to the top of the keypad.

3.If the clear floor space allows parallel approach by a person in a wheelchair, the maximum high side reach shall be 54” above grade to the top of the keypad.

4.If the high side reach is over an obstruction of 24” or less, the maximum high side reach allowed is 46” above grade to the top of the keypad.

?

?

?

!

EDGE OF TRAFFIC LANE

7