Quick Start Guide: Music & Audio
NOTE: VMC1 does not distinguish between audio from a room being monitored and audio from the tuner. If a room is to be monitored, it is recommended that the tuner be turned off.
Set Volume Level at Master Station
To change the speaker volume at the Master Station:
1.Turn Radio ON to provide an audio source
2.Press MUS button to activate speaker at the Master Station
3.Press Volume + (plus) or Volume – (minus) buttons to adjust level
Setting Volume Levels at Room Stations:
To change the speaker volume at any Room Station:
1. Press the Volume + or Volume – buttons to adjust level
Room station will emit a steady tone increasing or decreasing in level depending on the button being pressed.
This tone eliminates the need to have an audio source active at the Master Station while setting the desired volume level.
Your installer may disable this tone at each room station, however doing so will require an active audio source at
the Master Unit to set the volume levels. If this is disabled, follow the steps under Setting the Volume Level at the Master Station to set the volume levels at the Room Stations.
Privacy
Press PRIV button to disable microphone
This prevents any audio from transmitting. The Station continues to receive calls, however.
Point-To-Point and Whole House pages.
Page any Station where Privacy is active by following the
Answer Calls in Privacy Mode:
1.Press and release PRIV button to speak. Station now functions normally.
2.Press and release the PRIV button again to end conversation. Station remains in Privacy mode until disabled.
3.Press the PRIV button to disable Privacy Mode.
4