To Configure the Amplifier for
1Connect the left or right channel interconnect from your pre- amp or source component (depending on which channel of operation the amplifier is to be used for) to the CHANNEL 1 balanced XLR or unbalanced RCA input connector. Select the correct balanced or unbalanced input connector by flipping the Channel 1 BAL/UNBAL switch towards the connector that is being used.
2Flip the LINK INPUT 2 TO 1/UNLINK (NORMAL) switch “ON”, or up towards LINK INPUT 2 TO 1. Flip the LINK INPUT 3 TO 2/UNLINK (NORMAL) switch “ON”, or up towards LINK INPUT 3 TO 2. Flip the LINK INPUT 4 TO 3/UNLINK (NORMAL) switch “ON”, or up towards LINK INPUT 4 TO 3. Flip the LINK INPUT 5 TO 4/UNLINK (NORMAL) switch “ON”, or up towards LINK INPUT 5 TO 4. Flip the LINK INPUT 6 TO 5/UNLINK (NORMAL) switch “ON”, or up towards LINK INPUT 6 TO 5.
3Using the output terminal linking cables of your choice (see page 14), connect the output binding posts of CHANNEL 1 to CHANNEL 2, CHANNEL 2 to CHANNEL 3, CHANNEL 3 to CHANNEL 4, CHANNEL 4 to CHANNEL 5, and CHANNEL 5 to CHANNEL 6.
4Connect the corresponding left or right loudspeaker cable to the Channel 6 SPEAKER OUTPUT connector.
The signal connections are now complete. Please recheck your connections before operating the amplifier.
16
