Link electronic MC-6 owner manual

To Configure the Amplifier for Two-Channel Stereo, Vertical Tri-Amplification Use

1Connect the left channel interconnect from your pre-amp or source component to the CHANNEL 1 balanced XLR or unbalanced RCA input connector. Select the correct balanced or unbalanced input connector by flipping the Channel 1 BAL/UNBAL switch towards the connector that is being used.

2Connect the right channel interconnect from your pre-amp or source component to the CHANNEL 6 balanced XLR or unbalanced RCA input connector. Select the correct balanced or unbalanced input connector by flipping the Channel 6 BAL/UNBAL switch towards the connector that is being used.

3Flip the LINK INPUT 2 TO 1/UNLINK (NORMAL) switch “ON”, or up towards LINK INPUT 2 TO 1. Flip the LINK INPUT 3 TO 2/UNLINK (NORMAL) switch “ON”, or up towards LINK INPUT 3 TO 2.

4Flip the LINK INPUT 6 TO 5/UNLINK (NORMAL) switch “ON”, or up towards LINK INPUT 6 TO 5. Flip the LINK INPUT 5 TO 4/UNLINK (NORMAL) switch “ON”, or up towards LINK INPUT 5 TO 4.

5Connect your left woofer loudspeaker cable to the Channel 1 SPEAKER OUTPUT connector. Connect your left midrange loudspeaker cable to the Channel 2 SPEAKER OUTPUT connector. Connect your left tweeter loudspeaker cable to the Channel 3 SPEAKER OUTPUT connector.

6Connect your right woofer loudspeaker cable to the Channel 6 SPEAKER OUTPUT connector. Connect your left midrange loudspeaker cable to the Channel 5 SPEAKER OUTPUT connector. Connect your left tweeter loudspeaker cable to the Channel 4 SPEAKER OUTPUT connector.

The signal connections are now complete. Please recheck your connections before operating the amplifier.

22