Basic Troubleshooting
A summary of fault conditions and their causes and remedies are listed below.
The
Condition: | Cause: | Remedy: |
Front panel STANDBY/POWER BUTTON does not | Light bulb defective. | Remove STNADBY/POWER BUTTON from front panel |
illuminate after pressing, amplifier operates |
| and replace bulb located under button. Use |
normally: |
| replacement bulb kit and instructions supplied by |
|
| your dealer. |
Front panel STANDBY/POWER BUTTON lamp does not | Incorrect power connections or circuit breaker | Review Installation/Rear Panel Power Connections |
illuminate after pressing and amplifier does not | positions on rear panel of amplifier. | section of Owner’s Manual. |
operate normally. |
|
|
| Abnormal Operation of the | Contact your dealer immediately. |
Front panel STANDBY/POWER BUTTON reverts to | Excessive | Repair or replace source component. Identify and |
Standby Mode during listening but can be returned | source components. | correct abnormal conditions such as low frequency |
to normal operation: |
| rumble and/or acoustic feedback caused by |
|
| phono playback (if applicable). |
| Severe clipping of amplifier circuitry. | Reduce volume slightly or use higher efficiency |
|
| loudspeakers. |
AC MAINS CIRCUIT BREAKER switches OFF or will not | AC mains voltage too high for amplifier. | Consult your dealer immediately to have the |
remain ON: |
| amplifier reconfigured for the proper AC mains |
|
| voltage. |
| Abnormal operation of amplifier internal circuitry. | Contact your dealer immediately. |
50/60 Hz buzz noise in loudspeakers: | Ground loop condition created between | Use balanced system configuration if possible. |
| components in system. |
|
|
| Inspect interconnect cables for poor connection or |
|
| termination. |
32