Home Wireless-G Gateway

SNMP

SNMP is a popular network monitoring and management protocol. To enable SNMP, click Enabled. To disable

SNMP, click Disabled.

If enabled, then specify the IP address(es) allowed to have SNMP access. Select All to allow all IP addresses with no restrictions, IP address to specify a single IP address, or IP range to specify a range of IP addresses.

Device Name. Enter the name of the Gateway.

SNMP v1/v2: Get Community. Enter the password that allows read-only access to the Gateway’s SNMP information.

Set Community. Enter the password that allows read/write access to the Gateway’s SNMP information.

Trap Management: Trap to. Enter the IP address of the remote host computer that will receive the trap messages.

UPnP

UPnP allows Windows Me and XP to automatically configure the Gateway for various Internet applications, such as gaming and videoconferencing.

• UPnP. To enable UPnP, click Enable. Otherwise, click Disable.

IGMP-Proxy

If your multimedia application or device is not working properly behind the Gateway, then you can enable IGMP-

Proxy to allow multicast traffic through the Gateway.

• IGMP Proxy. To use this feature, select Enable. Otherwise, select Disable.

WLAN

Management via WLAN. This feature allows the Gateway to be managed by a wireless computer on the local network when it logs into the Gateway’s Web-based Utility.

When finished making your changes on this tab, click the Save Settings button to save these changes, or click the Cancel Changes button to undo your changes.

Chapter 5: Configuring the Home Wireless-G Gateway

38

The Administration Tab

Page 44
Image 44
Linksys HG200 manual UPnP, IGMP-Proxy