Chapter 4 | Advanced Configuration |
Ping Parameters
Target IP Address Enter the IP Address of the device you want to ping.
Count Set the maximum count to the target IP Address for each attempt.
Time Out Set the time out (in seconds) interval if the device does not respond.
Click Save Settings to save any changes.
Admin > Port Mirror
You can mirror traffic from any source port to a target port for
Admin > Port Mirror
Source Port The port whose traffic will be monitored.
Target Port The port that will mirror the traffic on the source port.
NOTE: The Switch supports
Click Save Settings to save any changes.
Admin > Factory Default
Restores the Switch’s factory default settings.
Admin > Factory Default
Click the Restore to Default button, then it will restore the factory default settings to the switch.
Admin > Reboot
Restarts the Switch retaining the current configuration settings.
Admin > Reboot
Click the Reboot button, then it will restart the Switch.
Admin > Save Configuration
This Save Configuration screen is used to save and retrieve the Switch’s configuration information using your Web browser.
Configuration Upload Select this option to load a previously saved configuration file (.cfg). To do so, perform the following steps:
1.Click the Browse button.
2.Locate the appropriate file and click Open.
3.Click the Upload button to load the file.
Configuration Backup Select this option to save the Switch settings to a configuration file (.cfg).
1.Click the Save button.
2.Click Save when prompted to open, save, or cancel.
3.Select the location where the file should be saved and click Save.
14 |
