Linksys WRTSL54GS manual Application Start and End Protocol IP Address Enabled, Tcp

Wireless-G Media Storage Link Router with SpeedBooster

5.I am not able to access the Setup page of the Router’s web-based utility.

•Refer to “Problem #3, I want to test my Internet connection” to verify that your computer is properly connected to the Router.

•Refer to “Appendix E: Finding the MAC Address and IP address for Your Ethernet Adapter” to verify that your computer has an IP Address, Subnet Mask, Gateway, and DNS.

•Set a static IP address on your system; refer to “Problem #2: I need to set a static IP address.”

•Refer to “Problem #10: I am a PPPoE user, and I need to remove the proxy settings or the dial-up pop-up window.”

6.I need to set up a server behind my Router and make it available to the public.

To use a server like a web, ftp, or mail server, you need to know the respective port numbers they are using. For example, port 80 (HTTP) is used for web; port 21 (FTP) is used for FTP, and port 25 (SMTP outgoing) and port 110 (POP3 incoming) are used for the mail server. You can get more information by viewing the documentation provided with the server you installed.

Follow these steps to set up port forwarding through the Router’s web-based utility. We will be setting up web, ftp, and mail servers.

1.Access the Router’s web-based utility by going to http://192.168.1.1 or the IP address of the Router. Go to the Applications & Gaming => Port Range Forward tab.

2.Enter any name you want to use for the Application.

3.Enter the Start and End Port range of the service you are using. For example, if you have a web server, you would enter the range 80 to 80.

4.Select the protocol(s) you will be using, TCP and/or UDP.

5.Enter the IP address of the PC or network device that you want the port server to go to. For example, if the web server’s Ethernet adapter IP address is 192.168.1.100, you would enter 100 in the field provided. Check “Appendix E: Finding the MAC Address and IP Address for Your Ethernet Adapter” for details on getting an IP address.

6.Check the Enable option for the port services you want to use. Consider the example below:

	Application	Start and End	Protocol	IP Address	Enabled
	Web server	80 to 80	Both	192.168.1.100	X
	FTP server	21 to 21	TCP	192.168.1.101	X
	SMTP (outgoing)	25 to 25	Both	192.168.1.102	X
	POP3 (incoming)	110 to 110	Both	192.168.1.102	X
When you have completed the configuration, click the Save Settings button.
Appendix A: Troubleshooting					54

Common Problems and Solutions